Hey guys Well, i’m new to Arduino, and really loving XOD, but it seams to lack lots of libraries. I’m trying to setup a DC motor with shield, and there is no tutorial , help page or anything related as far as I can find. This is the hardware: 28BYJ-48 5V 4 Phase DC Gear Stepper Motor + ULN2003 Dr…

Hum… Already saw that post, and ll it tells me is that there is no node yet, but the reply isn’t explicit on is anser and I still know the same. I can make it work in Arduino IDE, but i’m finding XOD very lacking …

How do you do it in Arduino IDE? If it is just setting pins HIGH/LOW, and then pulsing the stepper pin, you can use the digital-write node to set and pulse the same pins. You will need a separate digital-write node for each pin that needs set/pulsed. You will need something feeding the digital-writ…

In Arduino I’m actualy using a library, since the default library doesn’t have much options for stepper motors I’ll show the code of what a have so far (Make the stepper run with the push of a button) Still medling with it… #include <AccelStepper.h> #define HALFSTEP 8 // Motor pin definitions #d…

I’ll try your way… Just because I really liked XOD :stuck_out_tongue: can’t even understand why we still use C to program arduino, when a visual programming language like XOD can do it better and faster…

C/C++ will likely produce much smaller, faster-running code, but XOD is certainly easier to program with…assuming nodes for what you want to do exist. It is still better to use C++ inside XOD node for some things. As in this example, you can use lots of digital-write nodes to create a stepper node, …

Well, I’m still very green on Arduino… like got my first last week but I have experience with programming. Tryed it in XOD and didn’t even get close the Arduino IDE library also sucks… like, really bad to control steppers Found AccelStepper Library and I’ts already running… Actualy I don’t know …

For Arduino IDE Hardware: 28BYJ-48 5V 4 Phase DC Stepper Motor + ULN2003 Driver Board 1 Button + resistor https://www.aliexpress.com/item/Smart-Electronics-28BYJ-48-5V-4-Phase-DC-Gear-Stepper-Motor-ULN2003-Driver-Board-for-arduino/32706559510.html?spm=a2g0s.9042311.0.0.16784c4d6KcYm5 (Just bough…

Well, the post has been blocked (possible spam due to links), Admin will unblock it later.

I just pushed a lib that may help you: https://xod.io/libs/txgruppi/stepper-28byj48/

28BYJ-48 5V 4 Phase DC Stepper Motor + ULN2003 Driver Board

gweimer June 20, 2018, 6:01pm 2

If you search the forum for “stepper”, there is this post giving basic steps for setting this up: Stepper Motor Driver and LED’s

Topic		Replies	Views
28BYJ-48-5V + ULN2003 node needed	1	755	December 11, 2018
A4988 stepper motor drive Hardware Interfacing Questions	3	875	June 5, 2020
Stepper 28BYJ-48 library Look What I’ve Done	2	1015	July 4, 2019
Servos and steppers in xod Hardware Interfacing Questions	3	670	March 3, 2021
(Driver controller) to drive the 2 motor using XOD XOD Programming Questions	24	1672	September 12, 2021

28BYJ-48 5V 4 Phase DC Stepper Motor + ULN2003 Driver Board

Related topics