hi im Sean and im kinda new to XOD language , so i have a 4 relay module and want to control 3 pumps and solenoid vale. pump (1) for water outlet i.e removing the water from the reservoir , pump (2) pumps water into the hydroponic system , pump (3) pumps new clean water into the reservoir , soleno…

[WhatsApp Image 2022-05-12 at 4.14.04 PM]

hey that helped me a bit but how do I put the first relay off while the second on ? such that relay 1 is one for (time) then relay two comes on and relay 1 goes off then relay 2 goes off and the cycle repeats with a delay of 30 sec

Do you need relay2 to go on BEFORE relay1 goes off? The other thread shows how to have only one relay on at a time if you don’t need the over-lap. If you do need the overlap, then you will need another delay node that turns both relays on for the over-lap time (so each relay would need to be fed by …

so this is how the system should run (1)relay 1 turns on for 30 sec then stops, while relays 2 and 3 are off ( by default) (2)relay 2 and 3 turns on for 30 and 40 sec respectively then turn off this cycle is delayed for 5 min then starts again iv mentioned that the cycle should begin again only …

You are close. I don’t know what pulse-timed is; I would replace it with another delay node. delay-DONE would then link to defer node. You have relay-ACT linked to 2nd set of delay nodes. This would trigger when relay turns on as well as off, and is NOT what you want. Instead, delay-DONE from firs…

[jhjhjh] hey so i did what you told me to do but the relays are switching on and off in a random order

Not sure what happened, but I suggested that relay-ACK should NOT be used to pulse delay. This is more what I was suggesting: [image] This is very close to the code you originally posted, but instead of relay-ACK pulsing delay nodes, delay-DONE is always used to pulse the next delay node. Above c…

Hey So you aren’t using any kind of sensors to measure your fluid levels, and you just rely on the possibly quite same volume output of your pumps. I’m just wondering if your loop stops working after days of usage because your fluid levels are deliberately off and partly spilled on the ground …

His type of system doesn’t store all the water in buckets / totes (& maybe another reservoir), like the DWC (Deep Water Culture) systems, where the plants roots live in the water 24 x 7. His system pumps the water up to the roots, the plants live in those holes drilled into the top of those larger …

Controlling 4 relays for an automatic water flowing system for hydroponics

XOD Programming Questions

gweimer May 13, 2022, 2:03am 3

Sounds very similar to this discussion: Need some advice

Topic		Replies	Views
1 button 2 relays XOD Programming Questions	1	1178	December 14, 2021
Need some advice XOD Programming Questions	4	761	August 29, 2020
SSR control in XOD XOD Programming Questions	1	372	August 24, 2020
Help with very simple project	12	1250	November 28, 2019
Nextion and relays programming XOD Programming Questions	24	3016	September 8, 2020

Controlling 4 relays for an automatic water flowing system for hydroponics

Related topics