Board programming port did not appear

Hi everybody!

I’m an absolute beginner starting my first XOD sketch. When I try to upload it I get the message: Board programming port did not appear. When I use the original arduino Software it recognizes the port.

What can I do?

Hello and thanks for the report.

Could you provide more details?

  • What board model do you use?
  • If it’s a replica, what chip it is based upon?
  • What board model do you select in the Upload’s drop-down?
  • Are there any delay before the error or it is thrown immediately after Upload is being pressed?

Thank you nkrkv,

you already solved my Problem. I had selected the wrong board in the drop-down.

Oh well. I think we eventually should do board autodetection.

This topic was automatically closed 2 days after the last reply. New replies are no longer allowed.