# TCA9548A - 7ch i2C expander

**URL:** <https://forum.xod.io/t/tca9548a-7ch-i2c-expander/2931>\
**Category:** Uncategorized\
**Created:** [November 26, 2019, 4:05pm UTC](https://forum.xod.io/t/tca9548a-7ch-i2c-expander/2931 "2019-11-26T16:05:11Z")\
**Posts on this page:** 1\
**Showing post:** 2

<div class="post-metadata">

**Author:** ![robertspark](https://avatars.discourse-cdn.com/v4/letter/r/839c29/32.png) [@robertspark](https://forum.xod.io/u/robertspark)\
**Post date:** [November 26, 2019, 4:39pm UTC](https://forum.xod.io/t/tca9548a-7ch-i2c-expander/2931/2 "2019-11-26T16:39:51Z")

</div>

Looking at this example

> **[Adafruit TCA9548A 1-to-8 I2C Multiplexer Breakout](https://learn.adafruit.com/adafruit-tca9548a-1-to-8-i2c-multiplexer-breakout/wiring-and-test)**
>
> You just found the perfect I2C sensor, and you want to wire up two or three or more of them to your Arduino when you realize "Uh oh, this chip has a fixed I2C address, and from what I know about I2C, you cannot have two devices with the same address...

you don’t actually need a node / library.

you could try to use the standard i2c nodes (begin-transmission + write-byte) to send the signals you require to toggle the outputs.

Give it a go, good luck.

---

_[View the full topic](https://forum.xod.io/t/tca9548a-7ch-i2c-expander/2931)._